@article{oai:nagasaki-u.repo.nii.ac.jp:00007574,
 author = {杉山, 滋 and 熊本, 直樹},
 journal = {長崎大学教育学部自然科学研究報告, Science bulletin of the Faculty of Education, Nagasaki University},
 month = {Feb},
 note = {This report clarifies the effects of the inclination angle (i) of the knife upon the roughness of the workpiece cutting-surface and the deformation of the chip in the 90°-90°cutting (edge perpendicular, moving perpendicular to the grain direction) of wood. Air-dried specimens of different wood species having a wide range of specific gravity (ru) were used in this study, and were cut by feeding a knife, which was set on the experimental apparatus (Fig.2). The deformation of the chip and the roughness of the workpiece cutting-surface were observed relatively and estimated sensuously. The results of them were shown (Table 1 and Figs.3-5), and the effects of i and the workpiece conditions (ru, the wood species and the orientation of the annual rings to the cutting direction on the workpiece cutting-surface) upon them are discussed., 長崎大学教育学部自然科学研究報告. vol.40, p.67-82; 1989},
 pages = {67--82},
 title = {木材の木口切削におけるバイアス角の影響-2 : 被削母材切削加工面の精粗(削り肌)の変化と切屑の変形様相について},
 volume = {40},
 year = {1989}
}